General Safety Precautions; Safety Rules For The Operation Of The Scarifiers/Planers - Contec CT 200 Betriebsanleitung

PRoDUCt oVeRVIeW
1.1

General Safety Precautions

Safety rules for the operation of the Scarifiers/Planers

Information
The CT 200® floor planer / scarifyer has been developed according to existing safety rules
and regulations. The technical safety precautions must not be removed or changed under
any circumstances. When operating the milling machine, the following points should also
be observed:
Danger!
• The CT 200® floor planer / scarifier may only be operated with all protective safety covers and
technical precautions.
• The power must be disconnected when transporting, cleaning, repairing or maintaining the ma-
chine. This also applies to tool changes.
• The operator should never leave the machine during operation.
• The tool must be removed before the machine is transported.
• Before leaving the machine all rotary parts should be brought to a stand still.
• The electric models must be disconnected from the mains. Make sure that the machine cannot
roll or move by itself.
• After maintenance and adjustment all safety covers must be reattached.
• If unusual running noises or increased vibrations are registered during operation of the CT 200®,
the machine must be switched off immediately and the cause of the problem must be explored.
• After maintenance and repair work, the protective devices must be properly reinstalled.
• Noise protection equipment must be worn by the machinist.
• The machine operator must wear eye protection.
• The machinist must wear safety shoes with steel toecaps.
• If there is a lot of dust in closed rooms, the floor milling machine must be operated with an extrac-
tion system.
• For the petrol engine version CT 200P, sufficient ventilation must be ensured!
Attention!
Depending on the type of floor and coating, gases / dust can be released during milling. It
is the responsibility of the user whether these generated gases / dust may contain dange-
rous substances and whether protective measures have to be taken.
Floors containing asbestos are especially dangerous and can cause health problems. Spe-
cial masks must be worn by the operator which to filter breathing air. A dust collector must
be used and should be equipped with filters suitable for asbestos dust.
5