Mitutoyo 209 Serie Bedienungsanleitung Seite 8

Handling during measurement
Important:
The measuring axis
must be in vertical
position to the
measuring
surface!
Important:
The measuring axis
must be in vertical
position to the
measuring surface!
Important:
The fixed flat contact
must be square against
the part to be measured!
8
Determination of the minimum measuring value via pivoting
the gage (optimal measurement).
Measured value
too high
of the maximum measuring value for measurement
Determination
of narrow grooves via lateral displacement of the gage, where the
gage cannot be pivoted vertically.
Measured value
too small
For checking round parts it is advisable to use measuring gages with
chisel contacts ( Technical Data)!
Measurement of flat material (e.g. foamed material) with flat measuring
contacts.
The movable flat contact aligns optimally so a pivoting or moving of the
gage is not necessary.
Fixed flat
contact
Measured value
correct
Measured value
correct
Movable flat
contact
Measured value
too high
Measured value
too small