Product Label - Würth R-080-We Gebrauchsanleitung

1.) Definitions
1.1-1.3 Product overview
1 Lanyard (1.1, 1.2) / flexible anchor line (1.3)
2 Length adjustment device (1.1, 1.2) / Guided type fall
arrester (1.3)
3 + 4 Connector EN 362
5 Sewn terminations/end knots
6 Shock absorbing element
1.4 The connecting element at the guided type fall arrester may not
be extended! (EN 353-2)

1.5 Product label

1. Manufacturer + address
2. Lanyard length / the flexible leadership
3. Read instructions
4. Product description
5. Relevant standards + year of issue
6. Serial number
7. CE marking of the supervisory body
8. User identification
9. Next inspection
10. Manufacturer
11. Month and year of manufacture
12. QR code
13. In-house barcode
14. Article number
15. max. rated load, including tools and equipment
16. suitable for horizontal application (edge radius > 0,5 mm)
2.) Application
Application Guided type fall arrester on flexible anchor line
according to EN 353-2
The components of a complete system must never be used individually
or be replaced by non-certified products. The fall arrester must always
be used with the supplied rope.
The system should only be used in accordance with its intended
use. The guided fall arrester must always be attached to an
attachment point marked as „A" on the body harness (EN 361) (2.1
– 2.3).
During use, pay particular attention to sharp edges, the cable guide
and other things that could damage the rope or the fall arrester (2.5,
2.6).
Also ensure that all carabiners (EN 362) are firmly locked (3.4, 3.5).
Flexible anchor lines must be fastened to a suitable attachment point
(minimum load capacity of 12 kN, e.g. in accordance with EN 795,
14