Electrolux GA60SL3VS Benutzerinformation Seite 14

Water softener level
9
10
In case of the high water softener setting, it
may occur also in the middle of the
programme, before the rinse (twice during a
programme). Regeneration initiation has no
impact on the cycle duration, unless it occurs
in the middle of a programme or at the end of
a programme with a short drying phase. In
such cases, the regeneration prolongs the
total duration of a programme by additional 5
minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin in the
same cycle or at the beginning of the next
programme. This activity increases the total
water consumption of a programme by
additional 4 litres and the total energy
consumption of a programme by additional 2
Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more
than one in the same cycle) may prolong the
programme duration by another 5 minutes
when it occurs at any point at the beginning
or in the middle of a programme.
All the consumption values mentioned in
this section are determined in line with
the currently applicable standard in
laboratory conditions with water hardness
2.5mmol/L (water softener: level 3)
according to the regulation: 2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
7.3 Rinse aid level
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the hot rinse phase. It is
possible to set the released quantity of rinse
aid.
When the rinse aid dispenser is empty, the
display shows the indicator
14 ENGLISH
Amount of water (l)
3
3
and Rinse aid
low. If the drying results are satisfactory while
using multi-tablets only, it is possible to
deactivate the dispenser and the refill
notification. However, for best drying
performance, always use rinse aid and keep
the notification active.
To deactivate the rinse aid dispenser and the
notification, set the rinse aid level to 0.
7.4 End sound
You can activate an acoustic signal that
sounds when the programme is completed.
Acoustic signals sound also when a
malfunction of the appliance occurs. It is
not possible to deactivate these signals.
7.5 AirDry
AirDry improves the drying results. The
appliance door opens automatically during
the drying phase and remains ajar.
AirDry is automatically activated with all
programmes other than Pre-rinse.
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
When AirDry opens the door, the display
shows the remaining time of the running
programme.
CAUTION!
Do not try to close the appliance door
within 2 minutes after automatic opening.
This can cause damage to the appliance.