Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to carry the skis
Place one ski on the ground, then slide
the other one along the base from top to
bottom until the ski brakes (16) latch.
Accessories
The following accessories are available at
your ski retailer:
Crampons for skis with a waist width of:
max. 85mm, max. 100mm, max. 115mm
Ski stoppers for skis with a waist width of:
max. 85mm, max. 90mm,
max. 100mm, max. 115mm
Ski leashes
Using the crampons
Pivot the crampon (30) onto the binding
frame from the bottom up and slide it for-
ward until the cut-outs within the crampon
adapter (31) connect with the crampon
mounting points (19) of the binding frame
(13). Now push the crampon locking lever
(33) upward until it locks. Dismount in the
reverse order ill. (P,Q,R,S)
Caution: Use the crampon only on crud
snow or ice and only with a climbing aid
setting in stage 1 or 2! In stage 3 the cram-
pon teeth are too short and in stage 0 (flat
on the ski), they are too long. If you decide
to use the crampons in stage 0 on soft
spring snow, there is the chance of snow
build up between crampon and the surface
of the ski. This may lead to a strong charge
of the binding parts. Please try to avoid and
wax both the ski surface and the inside of
the crampon, if necessary.
Ski leashes
Also ski leashes can be used instead of ski
stoppers.
The ill. (T,U,V,W) indicate the mounting of
the leash to the heel piece (7). The lug (28)
has to be threaded through the slit accor-
ding to ill. (V), whereas the loose end of the
lug (28) has to point backwards.
Caution: Check whether the leash is secu-
rely engaged! If attaching the ring band to
the ski boot, make sure that the hook (27)
is securely linked with the ring (26).
The leash avoids loosing the ski in case of
a binding release, but definitely increases
the danger of injuries.
Worn or damaged leashes have to be
replaced.
05/11 © Hagan Ski GesmbH, Andiesen 11, 4774 St.Marienkirchen, Austria / Art. Nr. TU055-K
hagan Z
DESCRIPTION OF THE
BINDING PARTS
1
Toe piece
2
Toe sole holder
3
Adjusting screw lateral release
4
Adjusting scale lateral release
5
Adjusting scale front release
6
Adjusting screw front release
7
Heel cup
8
Opening lever
9
Pole hutch of the opening lever
10 Adjusting screw for forward pressure
and sole length
11 Lock for downhill mode and climbing
aid stage 1
12 Climbing aid lever
13 Main Frame
14 Gliding AFD
15 Ski brake pedal
16 Ski brake lever
17 Paper test stripe
18 Adjusting screw sole height (front)
19 Crampon mounting points
20 Pivot shaft
21 Binding screws
22 Rear standing platform
23 Rear side of the main frame
24 Base plate
25 Ski leashes
26 Ring
27 Hook
28 Lug
29 Slit
30 Crampon
31 Crampon adapter
32 Crampon lock
Care and maintenance
The warranted guarantee by hagan
presumes that the owners manual as well
as the warning notices have been followed
and taken care of. Make sure to get the
binding checked according to its function
and correct adjustment regularly or at
least before starting a new ski season.
Always store your skis with the binding
locked in a dry and cool, but frost-pro-
tected place.
Caution: Only use hagan approved lubri-
cants. Otherwise friction values could alter,
leading to unintended releases.
Warranty
The hagan warranty has to be conducted
by an authorized ski retailer. A case of
warranty takes place if the product or a
part of it does not function properly accor-
ding to defects in material or production.
The final decision about an objected defect
in production can only be taken by a person
which is assigned by hagan. hagan decides
whether a defective binding is going to be
replaced or repaired within a time range
of two years ex purchase date (rental- and
demo bindings: one year).
Warranty disclaimer
Exempted from warranty are damages
caused by improper use, non professi-
onal mounting, disregard of the owners
manual, incorrect adjustment, insufficient
maintenance and care, skiing accidents,
wrong use of the product or normal wear.
All wear parts like mounting plates, levers
and prints are exempted from the war-
ranty. Furthermore hagan is not liable for
causal or consequential damages of any
kind, unless such a limitation of liability is
distinctly prohibited by the legislator. Any
kind of warranty claim deduced from this
circumstance is distinctly rejected, unless
such an rejection is prohibited by the law.
In this case the awarded warranty claim is
only given in the above mentioned term of
guarantee.
According to DIN/ISO 13992 (Tour) and
DIN/ISO 9462. Tested and approved by the
TÜV-Süd Product Service GmbH, München
Made in Germany
All operating and mounting instructions
are available as a PDF data base at
www.hagan-ski.com
Hagan Ski Ges.m.b.H.,
Andiesen 11,
4774 St.Marienkirchen, Austria,
+43 7711 33133-0
Mail: info@hagan-ski.com
Artikel No. TU055K / issue 06.2010
Werbung
