EINHELL 45.015.68 Bedienungsanleitung Seite 21

Anleitung_BG-EC 1840_SPK1:_
under tension. Wood which is under tension from
which it is released by cutting may in some cases
react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or
even fatal injuries (Fig. 22-24).
This type of work must only be performed by persons
who have been specially trained.
7. Technical data
Mains voltage:
Power rating:
Cutter rail length:
Cutting length, max.:
Cutting speed at rated rpm:
Oil tank capacity:
Weight with cutter rail and chain:
Protection class:
Guaranteed sound power level under load 103 dB(A)
Sound pressure level under load
Acceleration: (calculated according to EN 50144)
Handle under load
8. Maintenance
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
the nose sprocket in the cutter rail is damaged or
worn.
Proceed as described in the section "Assembly of the
cutter rail and the saw chain".
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis in order to
guard against overheating and the associated
damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth
surface (board, section of a cut tree) and allow the
chainsaw to run.
If an increasing oil trace becomes evident during this
process then the automatic chain lubrication system
is working properly. If no clear oil trace is evident then
please refer to the corresponding instructions in
"Troubleshooting". If the information contained there
still fails to remedy the situation then please contact
our service department or another similarly qualified
workshop.
23.07.2008 8:38 Uhr Seite 21
Caution: Do not actually touch the surface with the
tip of the cutter rail when performing this test. Keep a
safe distance (approx. 20 cm).
8.3 Sharpening the saw chain
Effective working with the chainsaw is only possible if
the saw chain is in good condition and sharp. This
also reduces the risk of kickback.
The saw chain can be re-sharpened by any dealer.
Do not attempt to sharpen the saw chain yourself
unless you have the necessary special tools and
experience.
230 V ~ 50 Hz
1800 W
400 mm 9. Cleaning and storing
400 mm
Regularly clean the clamping mechanism by
13,5 m/s
blowing it out with compressed air or cleaning it
110 ml
with a brush. Do not use tools for cleaning.
5,75 kg
Keep the handles free of grease so that you can
II maintain a firm grip.
Clean the device as required with a damp cloth
and, if necessary, mild washing up liquid.
89 dB(A)
If the chainsaw is not to be used for an extended
period of time then you should remove the chain
5.3 m/s 22 oil from the tank. Briefly immerse the saw chain
and the cutter rail in an oil bath and then wrap
them in oil paper.
Caution:
Always disconnect the mains plug before
cleaning the chainsaw.
Never immerse the unit in water or other liquids in
order to clean it.
Store the chainsaw in a safe and dry place out of
the reach of children.
10. Notes on environmental protection
/ disposal
The device must be properly disposed of when it
reaches the end of its service life. Cut off the power
cable to prevent it being used by mistake. The device
must not be disposed of as domestic waste. Instead,
in the interests of the environment it should be
disposed of via a designated recycling or disposal
point for electrical equipment. Please contact your
local authorities for information about proper disposal
of the device in your area. Packaging materials and
worn accessory parts should also be disposed of at
the designated recycling or disposal points.
GB
21