IKEA FORSNAS Bedienungsanleitung Seite 8

ENGLISH
Installation
WARNING!
Before installing the appliance,
carefully read the safety information in Safety &
Warranty booklet.
WARNING!
Refer to the separate Assembly
Instructions to install your appliance.
WARNING!
Fix the appliance in accordance
with the separate Assembly Instructions to avoid a
risk of instability of the appliance.
Location
This appliance should be installed in a dry, well
ventilated indoor location. Do not install the appliance
near heat sources (e.g. ovens, stoves, radiators,
cookers and hobs) or in a place with direct sunlight.
If you have any doubts regarding installation,
please turn to the vendor, our customer service or
the nearest Authorised Service Centre.
It must be possible to disconnect the appliance
from the mains power supply. The plug must
therefore be easily accessible after installation.
Inspection checklist
Please follow the inspection checklist before using
your appliance. If any answer is "NO", follow the
relevant action. Remember to write down the product
serial number and article number as required and
attach your receipt to this page.
Product serial number (Ser. No.):
.....................................
Product article number (Art. No.):
.....................................
Purchasing date:
.....................................
To check
Make sure the gasket seals
all around the door when
each door is closed.
Check if there is no collision
between parts and furniture
while opening and closing
the doors.
Install the appliance as a
built-in appliance.
Make sure that at first
installation or after reversing
the doors the appliance
stands in the vertical position
for at least 4 hours before
it is connected to the power
supply.
If the answer is NO
Refer to the assembly
instructions - door
alignment.
Refer to the assembly
instructions - door
alignment.
Follow the assembly
instructions for
proper installation.
Wait 4 hours before
connecting the
appliance to the
power supply.
To download the full version visit www.ikea.com
Cleaning the appliance
Before using the appliance for the first time, clean the
appliance to remove the typical smell of a brand-new
product.
1. Make sure the appliance is disconnected from the
power supply.
2. Wipe the interior with a soft, moistened cloth.
3. Wash the internal accessories with lukewarm water
and some neutral soap, then dry thoroughly.
CAUTION!
Do not use abrasive, chloride or acidic cleaning
agents or solvents.
• Do not use scouring or abrasive sponges. The
metallic surfaces may corrode.
• Never clean the accessories using a dishwasher.
They may become deformed.
Electrical connection
CAUTION!
Any electrical work required to
install this appliance should be carried out by a
qualified electrician or competent person.
WARNING!
This appliance must be earthed.
Failure to follow these instructions can result in
death, fire or electrical shock.
The manufacturer declines any liability should these
safety measures not be observed. This appliance
complies with the E.E.C. Directives.
Replacing the lighting
The appliance is equipped with a LED for interior
lighting.
Only an authorized technician is allowed to replace
the lighting device. Please contact your Authorised
Service Centre. For a quicker service, always refer to
the full list of Authorised Service Centres located at
the end of Safety & Warranty or full UM and call the
corresponding phone numbers.
8