Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Information for Your Safety
This manual does not represent a complete listing of all the safety measures required to operate
the equipment (module, device) since specific operating conditions may make further measures
necessary. However, it contains information which you have to observe in order to ensure your
personal safety and in order to avoid material damage. The information is highlighted by a
warning triangle and, depending on the degree of danger, is shown as follows:
Danger
indicates that death, severe personal injury or substantial material damage will result if appropriate
precautions are not taken.
Warning
indicates that death, severe personal injury or substantial material damage may result if appropriate
precautions are not taken.
Caution
indicates that minor bodily injury or material damage may result if appropriate precautions are not taken.
Important
indicates that material damage may result if appropriate precautions are not taken.
Note
indicates important information about the device, its handling or the respective part of the instruction manual
to which attention should be drawn.
Qualified Personnel
Commissioning and operation of the equipment (module, device) described in this manual may only be
carried out by qualified personnel. Qualified personnel in the sense of the safety instructions in this manual
are persons who are entitled to commission, enable, earth and identify devices, systems and circuits in
accordance with the standards of safety technology.
Use as Prescribed
The equipment (device, module) may only be used for the applications described in the catalogue and the
technical specifications and only in combination with third party equipment recommended or approved by
Siemens.
The successful and safe operation of this device is dependent on proper handling, storage, installation,
operation, and maintenance.
Hazardous voltages are present in parts of this electrical equipment during operation. Severe personal injury
or material damage may result if the device is not handled properly.
•
The device is to be earthed to the protective-earth terminal before any other connections are made.
•
Hazardous voltages may arise in all the circuit parts connected to the power supply.
•
Hazardous voltages may be present in the equipment even after the power supply voltage has been
removed (capacitors may still be charged).
•
Equipment with current transformer circuits must not be operated openly.
•
The limit values specified in the manual or in the operating instructions must not be exceeded;
this must also be observed during testing and commissioning.
Digital Fault Recorder, SIMEAS R/SIMEAS R-PMU, Maintenance Manual
E50417-H1074-C364-A2, Release 11.2009
Foreword
57
Werbung
