5.3 Operation
1. Place the flexible poker vibrator into the concrete and push the rocker switch to the "I" (on)
position.
2. Allow the poker vibrator to vibrate for 3 to 4 seconds in one place in the concrete.
Figure 6: Operation procedure during the compacting of concrete.
3. Pull the flexible poker-vibratos out of the concrete and move it to the following place.
Approximately 50 cm further (figure 7).
4. Repeat procedures 5, 6 and 7, until you have compacted the concrete completely.
5. Press the switch in the "0" position.
6. After use, place the poker vibrator on a dry and stable surface.
7. Pull the plug out of the power socket.
8. Rinse the drive hose clean with water and a brush.
Figure 7: Vibration locations when compacting concrete floors
28/59
Gebruikershandleiding / User Manual / Bedienungsanleitung
P14E,
rev. 1.2: 16-03-20200