Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Operation
Read the safety aspects and operating instructions before use. If aspects are not clear to you, then
contact the manufacturer.
For the location and description of the poker vibrator's parts, which are mentioned in the text, we refer to
figure 2 in this manual.
5.1 Connection and disconnection of the poker vibrator
In the text below are numbers between brackets. These numbers are positions numbers and they
correspond to the numbers in the parts list for figure 6 "connecting the flexible poker vibrator".
Disconnect the power supply to the poker vibrator before you assemble or dismantle the
flexible poker vibrator.
Figure 5: connecting the flexible poker vibrator
5.1.1 Connection
1. Connect the flexible poker vibrator to the motor coupling as follows:
2. Push the hose coupling (3) over the motor coupling (1). The square ended flexible drive shaft
now slides into the drive pin.
3. Adjust the quick release and tighten it by pressing the handle down (4) .
5.1.2 Disconnection
To disconnect the flexible poker vibrator, proceed as follows:
1. Pull the handle of the quick release upwards (4).
2. Pull the hose coupling (3) from the motor coupling (1) and pull the flexible drive shaft out of the
drive pin (2).
5.2 Operation and application of the poker vibrator
Check that the flexible poker vibrator is correctly connected to the motor drive's spindle
Place the motor housing in the direct vicinity of where you are going to compact the concrete.
Check if the switch is in the "0" (off) position.
Connect the flexible poker vibrator to an alternating voltage mains of 230 V, 50Hz, which is provided with
an earth leakage switch. Or connect it to 115 V, 50/60 Hz, when using a 115 V electrical drive unit.
Connect the machine to the power supply.
27/59
Gebruikershandleiding / User Manual / Bedienungsanleitung
1. Motor coupling
2. Drive pin
3. Hose coupling
4. Quick release
P14E,
rev. 1.2: 16-03-20200
Werbung
