Herunterladen Diese Seite drucken

Sony TC-755A Bedienungsanleitung Seite 12

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Lubrication
To maintain
the optimum
performance of the TC-755A,
consult
your nearest Sony dealer or service personnel, once
a year, for
lubrication and inside check.
CAUTION:
BEFORE PROCEEDING, DISCONNECT THE AC POWER
CORD.
@Use light machine oil. Aveid excessive lubrication.
@ Remove the head cover, tension arms, and top panels.
@Capstan motor: Apply one drop of oil to the oil pipe.
@Capstan shafts: Lift the rubber cap and apply one or two drops
of oil.
Remove
the
rubber
cap,
E-shape
ring,
black
washer, transparent ring, and white ring.
Apply
one drop of oil to the pinch roller shaft and felt.
Wipe off rubber parts with denatured alcohol.
@ Wipe off all excessive oil.
@Replace
the top panels, tension arms
and head cover
as they
were installed.
@Pinch rollers:
1
5 Crt ra
;
>
@Oil pipe
@Capstan
@Pinch roller
12
EDITING
Editing by Duplication
For connection, see page 4.
If one recorder is inferior to the other in quality, use the better one
as a master
recorder for the playback
process,
to obtain better
S/N.
Editing by Splicing
PAUSE
(WITH CUE}
Cueing
1. Stop the tape with the PAUSE
lever in playback
mode
at the
portin to be spliced.
2. Move the tape across the playback head back and forth by turn-
ing both reels by hand.
3. While
listening
to cue
sound,
find the correct
portion
to be
spliced, and carefully mark it at the position of the playback
head
on the outer side of the tape with soft colored pencil.
Yellow will
be most distinctive.
Note:
Take care not to get excessive
marking
material on the
heads.
Any stain on the heads will cause contamination
and im-
pair tape-and-head contact.
Splicing
Use splicing tape and a demagnetized pair or scissors.
1. Neatly overlap the tapes to be spliced and cut diagonally.
2. Place the two diagonal tape ends together, outer side up, on a
flat surface.
Be careful to make ends meet but not overlap.
3. Apply a piece of splicing tape diagonally over the aligned ends,
and press it firmly.
4. Trim off the excessive splicing tape, slightly cutting into the
tape.

Werbung

loading