Kenwood UBZ-LH68 Bedienungsanleitung Seite 8

INSTALLING/ REMOVING BATTERIES
This transceiver requires 3 R6 batteries. Use high
quality alkaline batteries to enjoy longer periods of
battery life. You can also use an optional UPB-1 NiCd
battery pack {page 27}. The battery pack is shipped
uncharged. First charge the pack using an optional
battery charger (UBC-2 or UBC-4) {page 27}. For the
charging method, see the instruction manual that comes
with the charger.
1 Release the battery cover clip, then completely open
the battery cover.
• Remove the belt hook first if it has been installed.
Battery cover
2 Insert (or remove) the 3 R6 batteries or the battery
pack.
• Mate the battery polarities with those marked on the
battery compartment.
2
Battery cover clip
Label
Ribbon
Contacts