Kenwood UBZ-LH68 Bedienungsanleitung Seite 25

RESET
You may sometimes want to reset all the transceiver
settings to the factory defaults.
LAMP CONTROL
The lamp is used to illuminate the Liquid Crystal Display.
It turns ON every time you press the UP, DOWN, MODE,
or Mic 2 key (on the optional SMC-34 Mic), and when you
turn the power ON. The lamp will go out after 5 seconds.
• If you press any key or switch while the lamp is ON, the
lamp timer will restart the 5 second countdown.
• The lamp stays ON while holding down the UP or DOWN
key to continuously change channels or CTCSS numbers.
AUXILIARY FUNCTIONS
With the transceiver power OFF,
press and hold the UP and DOWN
keys, then press the POWER switch.
• Upon releasing the keys, a beep
sounds and Reset is executed.
19