RTW TouchMonitor TM7 Software-Upgrade-Anleitung Seite 10

If you want to update your software, please proceed as follows:
1. Copy the update fi le (rtw-tm-fw-n-n.bin, n-n: fi rmware version)
into the main directory of a USB 2.0 fl ash drive.
2. Unmount the USB 2.0 fl ash drive from the computer system!
Not till then remove it from your computer!
ATTENTION! - Unmounting from the computer system
shall be performed to avoid damage of the copied update fi le!
3. Remove the unmounted USB 2.0 fl ash drive from your computer
and insert it to one of the USB ports on TouchMonitor's rear panel.
EN-4 Software Update
5.
5.
4. If not visible, touch the empty space of the screen to display the
control bar.
5. Touch the Menu key in the right section of the control bar, then
the System key in the Main Menu.
6. Touch the Special key. The additional Start Firmware Update:
rtw-tm-fw-n-n key is displayed.
7. Touch the key. The update starts and takes about 10 minutes.
8. When the update is fi nished, the TouchMonitor reboots auto-
matically.
9. Touch the Menu key in the right section of the control bar, then
the Info key in the Main Menu.
10. Check the Software Version (the designation of the update fi le
should be displayed), the Serial Number and the Model Number.
Manual | TouchMonitor 7"/9" Series common