Makita DCU601 Betriebsanleitung Seite 13

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Dimensions (L x W x H) *1
Traveling speed
Maximum load capacity
Maximum climbing capacity
Minimum turning radius *2
Brake
Tire
Rated voltage
Net weight
Protection degree
*1. The maximum height when the carrier is lifted is 1,020 mm, requiring a space of 1,260 mm above the machine.
*2. Outer diameter when turning with front wheel as axis.
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
WARNING:
Never use Portable Power Pack PDC1200 or PDC01 with this product. Using them together
may cause personal injury or malfunction.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Do not change direction on slopes.
This machine cannot be used on
public roads.
Forward
Reverse
On flat ground
On slope (3 ° - 12 °)
Front wheel
Rear wheel
1,400 mm x 730 mm x 820 - 1,030 mm
Hand brake and support brake
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
13 ENGLISH
DCU601
5.0 / 3.5 / 1.5 km/h
1.0 km/h
300 kg
180 kg
12°
1,150 mm
Pneumatic tire
Pneumatic tire
D.C. 36 V
144 - 145 kg
IPX4
DC18SH / DC18WC
Do not load or unload objects on
slopes.
Do not use the machine for trans-
porting people.
Do not lift the carrier on slopes.
Load objects on the carrier evenly.
Do not load objects unevenly or only
on front side.