Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Starting, operation
When designing your plant, take into account that the stated values (e.g.burst pressure,
over pressure safety) apply depending on the material and thread used.
The respective values for your mounting torque and maximum pressure please
find in the documentation of your high-pressure equipment supplier.
Functional test
The output signal must be proportional to the pressure. If not, this might point to a
damage of the diaphragm. In that case refer to chapter 10 „Troubleshooting".
Open pressure connections only after the system is without pressure!
Observe the ambient and working conditions outlined in section 7 „Technical
data".
Warning
Please make sure that the pressure sensor is only used within the overload
threshold limit at all times!
When touching the pressure sensor, keep in mind that the surfaces of
instrument components might get hot during operation.
Caution
Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB
the
25
Werbung
