Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Important details
1. Important details
Read these operating instructions before installing and starting the pressure sensor. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications.
If questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.tecsis.de
The product data sheet is designated as DD 702/DE 702
Contact tecsis for additional technical support +49 69 5806-173
With special model number, please note specifications in the delivery note.
If the serial number on the product label and/or the 2D code on the hexagon gets illegible (e.g.
by mechanical damage or repainting), the retraceability of the instrument is not possible any more.
tecsis pressure sensors are carefully designed and manufactured using state-of-the-art
technology. Every component undergoes strict quality and environmental inspection before
assembly and each instrument is fully tested prior to shipment.
As the highly pressurised materials are subject to extreme loads a permanent load cycle
stability is only given to a limited extent. This applies in particular to dynamic applications.
According to this the pressurised parts of the P3298 are wear parts which are not included in
the warranty.
Use of the product in accordance with the intended use P3298:
Use the pressure sensor to transform the pressure into an electrical signal in extremly high
pressure applications > 1000 bar.
Knowledge required: Install and start the pressure sensor only if you are familiar with the
relevant regulations and directives of your country and if you have the qualification required.
You have to be acquainted with the rules and regulations on measurement and control techno-
logy and electric circuits, since this pressure sensor is „electrical equipment" as defined by EN
50178. Depending on the operating conditions of your application you have to have the corre-
sponding knowledge, e.g. of aggressive media or high pressures.
16
Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB
Werbung
