MYPV AC THOR Schnellstartanleitung Seite 3

AC•THOR / AC•THOR 9s – Quickstart
Commissioning
1. Select language
2. Select operation mode
3. Selection control source – where does the AC•THOR or AC•THOR 9s get the excess
information from?
AC•THOR / AC•THOR 9s Schnellstart / Quickstart, Version 231130
In addition to this short manual, a comprehensive operating manual is available under this link.
It may be necessary to update the firmware for operation. The procedure is explained in the
above-mentioned operation manual.
Commissioning takes place in a few steps and must be carried out when starting the AC•THOR or
AC•THOR 9s for the first time or after resetting to factory settings. The settings made can be
changed at any time afterwards.
Use the left and right arrow keys to see more options.
A comprehensive description of the operating modes and the possible settings via the display
can be found in the operating instructions mentioned at the beginning.
Use the left and right arrow keys to see more possibilities.
Besides the my-PV Meter and open communication protocols such as http, Modbus TCP,
Adjustable Modbus RTU and Adjustable Modbus TCP, as well as frequency control, pre-set
signal sources are available for many compatible manufacturers.
For some signal sources communicating via the network (LAN), the selection between "Auto"
(automatic search of the IP address of the control) or "Manual" (manual entry of the IP address
of the control) is possible. If a control type with the addition "Manual" is selected, the next step
is to set the IP address of the signal source.
In the case of a control mode with the addition "Manual", the IP address of the signal source
must not change during operation (e.g. by a DHCP router), otherwise the AC•THOR or AC•THOR
9s will lose the control signal.
Signal sources with the addition "Modbus RTU" are connected via RS485. A network connection
(LAN) is not mandatory but is additionally recommended by my-PV to use the cloud mode.
my-PV WiFi Meter
Instructions can be found
here
Compatible
manufacturers
Instructions can be found here
EN