Herunterladen Diese Seite drucken

BERGNER BG-50038-WH Bedienungsanleitung Seite 11

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 27
water flowing out, close the pump immediately. The purpose of the step is that pump the water of the
tank into the housing.
6. When the lamp in pump control switch is illuminated, you should press the pump control switch on
the "—" position again, there will be hot water flowing out. When the lamp in it is extinguished, close
the pump. The pre-heating is finished.
MAKE ESPRESSO COFFEE
1. Remove the funnel by turning it in clockwise. Add ground coffee to steel mesh with measuring
spoon, a spoon ground coffee power can make about a cup of top-grade coffee, then press the ground
coffee powder tightly with the tamper.
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the "Insert" position, and you can fix them into
coffee maker firmly through turn it anticlockwise until it is at the "Lock" position..
3. Pour out the hot water in the cup. Then place the hot cup (yourself cup) on removable shelf.
4. At the time, the lamp in pump control switch shall be illuminated, if it is extinguished, wait for a
moment, once the lamp in it is illuminated, you should press the pump control switch on the "—"
position, waiting for a moment, there will be coffee flowing out.
Note: During operation, if the indicator is extinguished, you must close the pump and stop to make
espresso coffee. After a few seconds, if the lamp is illuminated again, you can make espresso coffee
continued by pressing pump control switch to "—" position, the lamp is cycle on and off to maintain the
water temperature is hot enough.
5. You should press ON/OFF switch to "O" position manually when desired coffee is obtained or the
colour of coffee changes weak obviously, all indicators go out and the coffee maker stops working,
your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out through turn clockwise, then
pour the coffee residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: during making steam, the metal funnel must be assembled in position.
Method:
1. Prepare espresso first with container big enough according to the part "MAKE ESPRESSO
COFFEE", make sure that the steam control knob is at the OFF position.
2. Press the coffee/steam selector to the "—" position, the lamp in the pump control switch will be
illuminated, waiting for until the indicator in the coffee/steam selector is illuminated.
Note: During operation, the indicator in the coffee/steam selector will be cycle on and off to maintain
to desired temperature.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended
to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4. Turn the steam control knob slowly in anti-clockwise, steam will come out from the frothing device.
Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
5. Insert the frothing device into the milk about two centimetre, froth milk in the way moving vessel
round from up to down.
6. When the required purpose is reached, you can turn the steam control knob to OFF position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to
hurt!
7. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste
and if desired, sprinkle the froth with a little cocoa powder.
8. Press the ON/OFF switch to the "O" position to cut the power source off. All indicators will be
extinguished.
11

Werbung

loading