Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BEFORE THE FIRST USE
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with warm water
as follows:
1. Pour water into water tank, the water level should not exceed the "MAX" mark in the tank. Then
replace the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning, you can fill the tank with
water firstly, and then put the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh).
3. Place a jug on removable shelf. Make sure the steam control knob is on the OFF position.
Note: the appliance is not equipped with jug, please use yourself jug or coffee cup.
4. Connect to power source, turn the ON/OFF switch to the "—" position. The lamp in itself will be
illuminated .
5. Turn the pump control switch to the "—" position, the pump will pump water, when there is water
flowing out and close the pump by pressing the pump control switch to "O", pressing the coffee/steam
selector to the "O" position and waiting for a moment, the appliance begins to be pre-heated until the
inner lamp of pump control switch is illuminated, it shows the pre-heating is finish. Pressing the pump
control switch to "—" position again, and water will flow out.
6. After water not dropping out any more, you can pour the water in each container out then clean
them thoroughly, now you can start brewing.
Note: There may be noise when pump the water on the first time, it is normal, the appliance is
releasing the air in the appliance. After about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance
before making coffee, including the funnel, filter and cup, so that the coffee flavour can not be
influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level
should not exceed the "MAX" mark in the tank. Then place the tank into the appliance properly.
2. Select the two –cup mesh, Set steel mesh into metal funnel, make sure the tube on the funnel aligns
with groove in the appliance, then insert the funnel into the appliance from the "Insert" position, and
you can fix them into coffee maker firmly through turn it anticlockwise until it is at the "Lock" position.
3. Place a espresso cup (yourself cup) on removable shelf.
4. Then connecting the appliance to power supply source. Make sure the steam control knob is on the
OFF position.
5. Press the ON/OFF switch to "—" position, the lamp in itself will be illuminated, make the coffee/
steam selector on the "O" position. Press the pump control button on the "—" position, when there is
10
Werbung
