Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setup and outlets
Front view
WLAN LED
Services LED
DECT LED
Telephony LED
Internet backup LED
Internet LED
Power LED
USB 3.0 ports
WLAN button
DECT button
22
Rear view
Reset button
Analogue
telephone port
ISDN telephone
port (S-bus)
SG LAN port
LAN port
LAN port
WAN LAN port
SFP module
fibre-optic port
On/off button
Power output for
mains adapter
Requirements
Before installing, ensure that you can answer yes to the following questions:
>
For a new Internet connection or Swisscom service:
Have you received the
information letter
confirmation SMS for activating the connection?
>
Your existing phones need to be connected to the router
directly. Make sure that the phones have an RJ11 or RJ45
plug.
>
For start-up, you need a PC/laptop with an Ethernet cable.
It is not possible to start up the router via WLAN.
Have all the requirements been met? You can now proceed with the installation.
Notes on LEDs
LED
LED not illuminated
Flashing white
WLAN off
WPS mode activated
Service LED currently not in use
DECT off
Pairing mode activated
No telephony services
/ error
Backup stick installing
Internet backup stick not
connected
Keeps flashing quickly:
error during activation
Internet connection
No connection
initiating (signal reco-
gnised)
Start, configuration or
Router off / error
update process
with the serial number and the
RJ 45
RJ 11
White/Green
Red
-
Error
-
Error
Not all numbers
are registered-
Telephony activated
Registration in
progress
Service ready
Error
Flashing red/white:
Internet backup in operation
Internet connection
active (IP address
Error
assigned)
Router is ready for
Error
operation
Blue
WLAN on
DECT on
-
E
-
-
-
23
Werbung
