6.2
Setting the operating mode
Verify that the upper part of the housing has been removed from the base.
A
A. Mains fuse F1
B. Slide switch for operating modes
C. Operating mode "Probe 1"
1. Loosen the grey cover from the upper part of the housing by means of a
small screwdriver.
2. Pull the printed circuit board out of the upper part of the housing.
3. Set the slide switch (B) next to the green LED to the required position.
4. Refit the printed circuit board.
All manuals and user guides at all-guides.com
Commissioning
B
D. Operating mode "Filling"
E. Operating mode "Emptying"
EN
C
D
E
27
RG 210