SEVERIN HH 6310 Gebrauchsanweisung Seite 7

Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance. This product
complies with all binding CE labelling
directives.
Important safety instructions
●
Caution: do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin filled
with water or near any other receptacle
containing water. Protect the appliance
from moisture and splashing water and
do not operate it with wet hands.
●
In the vicinity of any water source, there
is a risk even when the appliance is
switched off. Therefore, always remove
the plug from the wall socket after use,
especially if the appliance is being used in
a bathroom.
For additional protection, the installation
of a residual current device (RCD)
having a rated residual operating current
not exceeding 30 mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
●
This appliance is not intended for use by
any persons (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
Before the appliance is used, the main
body as well as any attachments fitted
Drying hood
should be checked thoroughly for any
defects. If the appliance, for instance, has
been dropped onto a hard surface, it
must no longer be used: even invisible
damage may have adverse effects on its
operational safety.
●
The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
●
Do not operate the appliance unless it is
properly fitted to its stand.
●
Always protect the drying hood and the
switch in the power cord from wet.
Always ensure that the power cord is not
pulled, twisted or excessively bent.
●
To prevent the drying hood from
overheating, ensure the air intake and
outlet slots are not covered.
●
Do not insert any objects into the
housing or any other parts.
●
Always switch off and remove the plug
from the wall socket after use, and also
- in case of any malfunction,
- during cleaning.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
Do not store the appliance until it has
cooled down completely.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Assembling the drying hood and stand
- Fold out the stabilising bars on the base.
7