urmet 1099/210 Schnellanleitung Seite 24

4.2 HOW TO ADD THE CAMERA TO A WI-FI NETWORK USING AP MODE
This mode is used to configure the wireless network interface of the camera without wiring it to the
network.
The camera is automatically set to Access Point mode if it was never configured in a Wi-Fi network.
Configuration have to be performed via a smartphone with the iUVSpro app.
In this case, the network configuration can be carried out after mounting and powering the camera in
its final location.
The following steps must be performed for configuration:
1. Power on the camera
2. Run the iUVSpro app
DS1099-157A
and select "Device List" from the side menu
24