Pioneer A-22 Bedienungsanleitung Seite 6

PANEL FACILITIES
LOUDNESS switch CD DIRECT switch/indicator
Use this switch/indicator when you do not wish to pass the output
from a piece of equipment connected to the CD terminals through
the various frequency adjusting circuits (BASS, TREBLE,
BALANCE).
The LOUDNESS circuit will continue to operate, however.
[ON] — When the switch is in this position, the indicator lights and
the signals input from the CD terminals are reproduced without
passing through the various frequency adjusting circuits.
This results in flat, pure sound which is a more faithful reproduc-
tion of the digital source.
[OFF] — When the switch is in this position, the indicator goes
out, and the signal selected by the FUNCTION switches are
reproduced.
NOTE:
When this switch is ON, the signals from the source connected to
the CD terminals are output from the speaker system, and also the
Signals from the source selected by the function switch are output
from the TAPE 1 REC terminal and the ADAPTOR/TAPE 2 ter-
minal. Consequently, if you wish to compensate the sound from
the source connected to the CD terminals using recording equip-
ment or an adaptor, press the CD function switch to select the
source connected to the CD terminals.
Use when listening at ow volume levels.
[OFF] — Released position: Should normally be left in this posi-
tion.
[ON] — Depressed position: Boosts low and high frequencies to
give added punch to play back even at low volume.
WM PIONEER = stenco amie micn Aee
ian.
Seer Sa mercy runcron
— FOR co
a eee
MAGTER VOLUME,
Mn th te
POWER
PHONES SPEAKERS Bsoe
©
pee gp Max
Str rir
ie]
Leer
VOLUME control (MASTER VOLUME)
Use to adjust volume level.
Move to MAX side to increase volume.
Move to MIN side to lower volume.
FUNCTION switches/indicators
Use to select playback source.
[PHONO] — Press when listening to record playback on a turn-
table.
[TUNER] — Press when listening to AM or FM broadcasts with a
tuner.
[CD] — Press when listening to a compact disc playback with a
CD player.
[TAPE 1]—Press when listening to tape playback with a tape deck.
ADAPTOR/TAPE 2 switch/indicator
Use when there is an adaptor component (graphic equalizer, etc.)
or tape deck connected to the ADAPTOR/TAPE 2 terminals.
[OFF] — Indicator goes out. When not in use.
[ON] — Indicator lights: When using the adaptor component
or listening to the tape deck.
NOTE:
When no connections are made to the ADAPTOR/TAPE 2 ter-
minals, or when they are not in use, be sure to set this switch to
the OFF position. (No sound will be heard if it is set to the ON posi-
tion.)
S
<ARE1039>