Pioneer A-22 Bedienungsanleitung Seite 2

READ [INSTRUCTIONS — All the safety and
operating instructions should be read before the
appliance is operated.
RETAIN INSTRUCTIONS — The operating instruc-
tions should be retained for future reference.
HEED WARNING — All warnings on the appliance
and in the operating instructions should be adhered
to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be followed.
WATER AND MOISTURE — The appliance should
not be used near water — for example, near a
bathtub, washbow/l, kitchen sink, laundry tub, ina
wet basement, or near a swimming pool, etc,
LOCATION — The appliance should be installed in a
stable location.
WALL OR CEILING MOUNTING — The appliance
should not be mounted to a wail or ceiling.
VENTILATION — The appliance should be situated so
that its location or position does not interfere with
its proper ventilation. For example, the appliance
should not be situated on a bed, sofa, rug, or
similar surface that may block the ventilation open-
ings; or, placed in a built-in installation, such as a
bookcase or cabinet that may impede the flow of
air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources such as radiators, heat registers,
stoves, or other appliances (including amplifiers)
that produce heat.
POWER SOURCES -— The appliance should be con-
nected to a power supply only of the type describ-
ed in the operating instructions or as marked on the
appliance.
POWER-CORD PROTECTION — Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cords
at plugs, convenience receptacles, and the point
POWER LINES — An outdcor antenna should be
located away from power lines.
NONUSE PERIODS — The power cord of the ap-
pliance should be unplugged from the outlet when
left unused for a long period of time.
OBJECT AND LIQUID ENTRY — Care should be
taken so that objects do not fall and liquids are not
spilled into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by Pioneer authorized service
center or qualified service personnel when:
The power-supply cord or the plug has been
damaged; or
Objects have fallen, or liquid has been spilled into
the appliance; or
The appliance has been exposed to rain; or
The appliance does not appear to operate normally
or exhibits a marked change in performance; or
The appliance has been dropped; or the enclosure
damaged.
SERVICING — The user should not attempt to service
the appliance beyond that described in the
operating instructions. For all other servicing, con-
tact the nearest Pioneer authorized service center.
POWER LINES
SERVICE
ENTRANCE
CONDUCTORS
STAND OFF
INSULATORS b
OUTDOOR ANTENNA GROUNDING — If an
outside antenna is connected to the antenna
terminal, be sure the antenna system is
grounded so as to provide some protection
against voltage surges and built up static
charges.
in the U.S.A. section 810 of the National Elec-
tricat Code, ANSI/NFPA No. 70-1984, pro-
vides information with respect to proper
grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an anten-
na discharge unit, size of grounding conduc-
tors, location of antenna-discharge unit, con-
nection to grounding electrodes, and re-
quirements for the grounding electrode. See
Fig. A.
Use No. 10 AWG (5.3 mm?)
copper, No. 8 AWG (8.4
mm?) aluminum, No. 17
AWG (1.0 mm?) copper-
clad steel, bronze wire, or
larger as ground wire.
Secure antenna lead-in and
ground wires to house with
stand-off insulators spaced
from 4 feet (1.22 meters} to
6 feet (1.83 meters) apart.
Mount antenna discharge
unit as closely as possible to
where lead-in enters house.
Use jumper wire not smaller
than No.6 AWG (13.3 mm?}
having one blade wider than the other). This plug ; :
will fit into the power outlet only one way. This is a SERVICE ENTRANCE CLAMPS fo ing electrode is used.
safety feature. If you are unable to insert the plug fournmes WIRE a,b
fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician
to replace your obsolete outlet. Do not defeat the eeweNeenACE
safety purpose of the polarized plug. GROUNDING V ELECTRODE system
aa i ' PTIONAL ANTENNA
scent : itty oe peng sd Sa only | ar
with a polishing cloth or a soft dry cloth. Never AONDING I ORIVEN 6 FEET (2.44 mt
y *, . : eas INTO THE EARTH IF
clean with furniture wax,
benzine, insecticides or
JUMPER UE
INTO THE A
other volatile liquids since they may corrode the
cabinet.
where they exit from the appliance. eee
POLARIZATION ~ If your purchased product is pro- |
vided with a polarized power plug, please read the TORN AT nie CHANT
following instructions. This product is equipped
GROUND
, Ps, GROUND
1 {- CLAMPS
LOCAL CODES SEE
NEC SECTION 810 21411
IMPORTANT 1
RISK OF ELECTRIC SHOCK
DO NOT OPEN \
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
The fightning flash with arrowhead, within an
equilateral triangle, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
IMPORTANT 2
If the apparatus is fitted with AC mains power outlet{s),
see REAR PANEL FACILITIES for convenient connec-
tion of additional Hi-Fi component(s). Make ail connec-
tions to the AC outlet(s) and the siqnal terminals first.
Connect the plug to the wall socket last, make sure that
the power switch is off. Disconnect the wall plug when
the equipment is not in (regular) use, e.g. when on
vacation. . ?
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL.
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this ap-
paratus may not correspond with the coloured marking i
identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or col-
oured black.
The wire which is coloured brown must be connected to
the terminal which is marked with toe letter L ar col-
oured red,
Equipment sold in the U.K. is not supplied with a
power plug.
2
<ARE1039>