osann Flux Isofix eXT Bedienungsanleitung Seite 21

Isofi x connectors
• Press the two side Isofi x connector buttons
to extend the length of the Isofi x connectors.
• Guide the Isofi x connectors to the Isofi x an-
chor points on the car seat and snap them
into place.
• Push the child car seat in until it rests securely
against the backrest of the vehicle seat. En-
sure that both Isofi x indicators are showing
green.
Top tether for size76-120 cm
• Remove the top tether from the storage bag
at the back of the child car seat (storage bag
depends on variant).
• To release the top tether, press the button
with one hand and pull the side of the belt
anchor to the required length with the other
hand.
• To fi x the top tether, clip the anchor to the fi x-
ing point on the car seat and pull it as tight as
possible. The display does not turn green until
the belt is tightened suffi ciently.
• The top tether harness is only required for the
76-120 cm size category. In the 100–150 cm
size class, the top tether strap is no longer
needed. In the 100-120 cm size range, you can
choose between the two installation variants.
- 21 -
EN