Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working
system
•
Soft material, leaves and twigs can be shreddered
directly in the main hopper.
•
Thick material and branches must be fed using the
side hopper.
•
Do not operate the machine unless the engine, or
electric motor, is running at full speed.Do not allow
the engineto labourbut feedat a rate which allows it
to maintain rates speed throughout the operation
cycle.
•
Do not force material into the hopper as this could
overload the machine and cause damage not covered
by the warranty.
Main Hopper
Material fed into the main hopper, reachesthe hammers
directly. Dccauscof this only light wcight material should
be fed in this way.
Important:
The hammer action generally pulls material through the
hopper
without
manual
blockages use the feeding tools supplied and under no
circumstancesattempt to push it down manually.
Side Hopper (Branch-Cutter)
Usethis for all long materialandthick branches up to the
capacity limit of the machine. Do not force material in so
fast that the engine is forced to labour.
Cutting screen (optional)
This should only be used with dry material which is then
re-chopped until it is quite fine..
Important:
Never use this for damp material, which will otherwise
block up andjam it.
Note:
Damp material should be shreddered with the screen
folded down in the horizontal position.
Prevention
of pile-up
Keep outlet clear, Always
space from outlet for the material being chopped.
assistance. In
the case of
during
ejection
check that there is enough
The Shredder 4000 Profi is not a soil processing
machine
Do not shred eatth manure or com ost in this unit.
Maintenance
of
•
Only work on the machine if the mainsplug or spark
plug leadaredisconnected.
•
Tighten the hardware after the first hour of use and
then at regular intervals until stable
•
Regularly checkbelt tension,particularly after heavy
work.
Turning
or replacing
(This work should only be carried out by trained
personnel)
•
Slop the machine or remove the supply plug or spark
plug as appropriate
•
Remove the discharge hopper.
•
Remove the V-belt cover (D.
• Pull outthetwo (if screen is fittedfour)pinsO.
• Pull out thegrille belts@ andfold downthevertical
grill@ andthescreen O (if fitted).
•
Remove the shaft cover O.
• Remove thelocationpin (D.
Extract
the hammer
shaft
machine. Take care to keep the removed parts in order by
threading them on a wire or other bar so they can be
replaced in the correct sequence. After
replacing
the hammers, please assemble all
components in the correct order. Refit the safety ring and
secure with a new location pin. Check for free rotation
whenever the hammers have beenturned or replaced..
7
the Shredder4000
hammers
from
the left
hand
side of the
turning or
the
Werbung
