TFA 30.1067.15 Bedienungsanleitung Seite 12

TFA_No. 30.1067_Anleitung
Digital window thermometer
• The maximum and minimum values are auto-
matically reset: The maximum temperature at
8:00 and minimum temperature at 20:00
o'clock. Therefore, the current time must be
set.
6.1 Set the clock
• Press the SET button. The hour digit (H) flash-
es for 20 seconds on the display.
• Press + button to adjust hours. Press and
hold the button for fast mode.
• Confirm the setting with the SET button and
set minutes (M) in the same way. Press the
SET button again to return to normal mode.
7. Mounting
• Screw the battery cover back on carefully.
• Remove the protective film from the adhesive
tape and attach the holder to the outside of the
window. Please clean the window glass
before. The device can now be easily clipped
in and out.
15.12.2023
– 22 –
11:19 Uhr Seite 12
Digital window thermometer
• Caution: Avoid direct sunshine. It falsifies the
indicated values! Extremely high temperatures
may lead to damages of the display. Perma-
nent sunshine may bleach the liquid crystals.
• Important note: Due to the heat emission
(depending on isolation) and the protected
location of your window it is possible that the
temperature displayed is higher than the out-
door temperature at a free unsheltered loca-
tion directly over the ground.
8. Battery replacement
• As soon as the display becomes weaker,
remove the device from the holder and replace
the battery. Screw the cover back on carefully.
9. Troubleshooting
Problem
No display on the device
➜ Ensure that the battery polarity is correct
➜ Change the battery
Solution
– 23 –