Using Your Tv For The First Time - Loewe Concept 55 Bedienungsanleitung

Using your TV for the first time.
This section deals with the operations
necessary when using your set for the
first time. They include setting the TV
standard, locating and storing the
programs to be received by you and
certain fine adjustments. If your dealer
has already carried that out for you, you
can skip this section. Go to page 35
"Operation".
Switching on.
Switch set on for the first time with the
power switch ©.
On-screen display in English, French
and Spanish, as well as German.
Your new Loewe will display all setting
operations on the screen.
The screen display is initially in
German. It can be changed over to the
other languages.
Open the sliding cover of the
remote control to its fullest extent. Press
the @ key. Letters indicating the display
language will appear on-screen <OSD
D deutsch> (OSD = On-Screen
Display). Press the large button © or ©
until the desired language is displayed.
Press the @) key. The display will
disappear; your language is now
programmed.
Program search and storage.
To enable you to select the TV programs
directly with the numeric keys
subsequently, they must first be stored.
There are two ways of doing this - either
locate the station with the Station
Search or input the channel number of
a station directly.
Setting the TV standard.
Germany uses the PAL television
standard. Other countries use the
SECAM-B/G standard, e.g. in Saudi
Arabia, Lebanon, Tunisia, etc. Your TV
will recognize these standards when
receiving a station and will set the
correct standard automatically.
Your Loewe is also equipped to
receive other standards, such as
SECAM-L (French standard), SECAM-D/K
(Eastern European TV standard) and
NTSC (US standard). Your set will not
recognize the other standards
automatically. The standards must
therefore be set manually before
searching for a TV station. To set other
TV standards, proceed as follows:
For this purpose, open the sliding cover
of the remote control to its fullest extent.
Call up display of the programming line
with the "Programming" key @) (depress
for two seconds).
The programming line will be visible at
the bottom of the screen. The line will
display the following:
LHS:
Channel = Channel for TV stations
or
Cable-Ch = for Cable channels with
channel number
Centre:
PAL or
SEC-L
SEC-D
NTSC
NTSCV
RHS:
Program name which you can input
yourself;
= TV Standard
Program number which you must
specify yourself.
Press the @) key again:
The TV standard will now appear on the
screen on a blue background, e.g. PAL.
You set the_TV standard required with
the © or © key. The abbreviations for
the standards are as follows:
PAL = PAL (Germany,
Switzerland, Austria,
Scandinavia, Benelux
Countries etc.)
SEC-L = SECAM-L (France)
SEC-D SECAM-D/K (Poland,
Czechoslovakia, Hungary
etc.)
NTSC = NTSC (USA and AFN in
Europe)
NTSCV = Special standard of certain
When the correct TV standard has been
set, press the key. Then go on to
station search.
31