Connecting The Tv Set; Connecting The Soundbar Klang Bar I; Connecting Antennas - Loewe SL7 Erweiterte Bedienhinweise

Loewe bild | Extended operating instructions

Setup

Connecting the TV set

Before making any connections to an external devices, make sure both TV set and device are disconnected from power�
Most TV connectors are hidden under the back cover� To access these connectors, you must remove the back cover by pulling the top and bottom
parts away as shown in the illustration� Both parts are held in place only by magnets, so there is no need to use any tools or remove screws�
When connecting external devices to these internal connectors, first connect the cable to the connector on the TV set� Then route the cable out of
the TV using the built-in cable management system, and then route the cable through the neck of the stand (in case you use provided Table stand
solution)�
When you have finished connecting external devices to the TV, replace the back cover�

Connecting the soundbar klang bar i

bild i set variants are provided with a klang bar i soundbar� Alternatively, you can buy a klang bar i as optional component for your standard bild i TV�
klang bar i soundbar is provided in a separate carton box, where you will also find detailed assembly instructions� Follow these instructions to
install the soundbar on the TV�

Connecting antennas

Terrestrial / cable analogue /
DVB-T/T2/C HD antenna:
Plug the cable of antenna, cable TV system or room antenna into the ANT TV socket.
If you want to use analogue cables/DVB-C connection and a DVB-T antenna together, use an external antenna switch (available from your dealer).
Satellite antenna DVB-S/S2 HD:
Connect a connecting cable from the from the LNB to the ANT SAT socket of the TV set.
Cable D V B T -
analogue /
DVB-C
R TV
ANT
TV
52
D V B S -
ANT
SAT