Werbung
Verfügbare Sprachen
Verfügbare Sprachen
forward
to remove
it from
the
boi-
(51020).
ler. Pull the light socket and cable
Attention!
downward
to take them
out of the
drive rods do not bind. Binding
lantern. Remove and replace the
can cause serious damage
light bulb. Reassemble.
model. (Fig. 7).
Rear lanterns:
Remove the ring
Replacing the brushes, pick-up
around the lantern lens. Carefully
shoes
pry the lens away from the lan-
- Remove
tern. Using tweezers, remove and
Replacing the motor).
replace the bulb. Reassemble.
- Remove
Cab light: Using tweezers, remo-
that
ve and replace the bulb.
connecting
Replacing the smoke generator
wheels. Pull the drive rods away
- Pull the safety ring out of the
from
smoke stack (Fig. 3).
- Remove
- Use pliers or tweezers to pull the
that attach the connecting rods
old smoke generator out of the
to the remaining wheels. Remo-
stack (Fig. 4).
ve the connecting rods.
- Cut the wires to the old genera-
- Remove the remaining
tor and attach them to the repla-
screws
cement generator (Fig. 5).
gearbox (Fig. 6). Remove the
- Insulate
the
connections
and
bottom of the gearbox.
push the replacement generator
- Remove the power strips.
into
the
stack.
- Take
- Reassemble.
gearbox.
- Make sure to replace the safety
- If necessary, replace the brus-
ring.
hes, pick-up shoes or wheel-
sets. Reassemble.
Replacing the traction
tire
Hint:
- Use a small, straight-blade scr-
shoes,
ewdriver to pry the old traction
contacts
tire out of the wheel groove.
metal retaining strips.
- Use a small, straight-blade scr-
ewdriver to gently pry the new
Attention!
traction tire into the wheel groo-
replaced,
the gears with LGB Gear Lubri-
ve.
- Make sure that the traction
tire is
cant (51020).
completely in the wheel groove.
Attention!
drive rods do not bind. Binding
Replacing the motor
can cause serious damage to the
- Remove the gearbox:
model (Fig. 7).
- Remove
the
hex
head
screws
Attention!
that
connect
the drive
rods and
gearbox, make sure that the lead
the connecting rods to the third
wheel assembly and spring can
axle (Fig. 6).
move freely.
- Remove
the
front
buffer
bar.
It
snaps into place.
- Counting from the front, remove
the
second
and
fifth
screw
on
the bottom of the gearbox.
- Remove the gearbox from the
chassis.
- Disconnect the wiring cable.
- Remove the top of the gearbox
by removing two screws. Repla-
ce the motor.
- If necessary, remove the idler
gears by pressing them upward
out of the gearbox housing.
- Reassemble.
Attention!
If the
motor
is remo-
ved, generously
lubricate
the
gears with LGB Gear Lubricant
Make
sure
that
the
to the
and
wheelsets
the
gearbox
(see
the
hex
head
screws
attach
the
drive
rods
and
rods to the rear
the
rear
wheels.
the
hex
head
screws
three
on
the
bottom
of
the
the
wheelsets
out
of the
To replace
the pick-up
lift
and
turn
the
wire
to allow
removal
of the
If the
wheelsets
are
generously
lubricate
Make
sure
that
the
When
closing
the
9
Werbung
