Belden Hirschmann OZD FIP G3 Serie Handbuch Seite 36

3 Setting Up
Mounting on DIN rail
Engage the upper snap-in hooks of the repeater in
the DIN rail and press the underside (as shown
in Fig. 7) onto the rail until it engages.
To remove the repeater, disengage by pulling the
locking slide downwards.
Mounting on mounting plate
The repeater has three through-holes to permit mounting
to any flat surface, e.g. on the mounting plate of a switch
cabinet.
Locking
slide
Fig. 7: Mounting repeater on DIN rail
34
All manuals and user guides at all-guides.com
Make three holes in the mounting plate corresponding
to the drilling template in Fig. 8.
Secure the repeaters with machine bolts (e.g.
M 3 x 40).
Ensure reliable electrical connection between the
repeater housing and the mounting plate. Place
toothed washers under the bolt heads to pierce the
varnish.
Fig. 8: Mounting repeater on mounting plate
3.2 Mounting repeaters
OZD FIP G3
System
Port 1
Port 2
Port 3
Port 1
Toothed washer
OZD FIP G3 ...
61.2 mm
Ø 3 mm
Ø 3 mm
Version 3.2 08/07