Werbung
2. With the Navigation-Buttons ( ▲▼) choose the option "Setup" and press the OK-Button.
3. With the Navigation-Buttons ( ▲▼) choose the option "Services and Recordings" and press the
OK-Button.
4. With the Navigation-Buttons ( ▲▼) choose the option "Service Searching" and pressthe OK-Button.
5. With the Navigation-Buttons ( ▲▼) choose the option "Tuner configuration" and press theOK-Button
Button.
6. With the Navigation-Buttons ( ▲▼) choose the option "DVB-S2 Tuner" and press theOK-Button.
7. With the Navigation-Buttons ( ▲▼) choose the option "Mode".
8. With the Navigation-Buttons (◄►) choose the option "DiSEqC A/B".
9. With the Navigation-Buttons ( ▲▼) choose the option "Port A".
10. With the Navigation-Buttons (◄►) choose the desired Satellite.
11. With the Navigation-Buttons ( ▲▼) choose the option "Port B".
12. With the Navigation-Buttons (◄►) choose the desired Satellite.
13. Press the OK-Button to save this settings.
Make sure you know which satellite is connected to which input on the Toneburst switch. If you do not find any services in
the transponder scan later, exchange the two satellites in this list and try again.
If you have trouble with "Tune failed" messages please set the "Send DiSEqC only on sattelite
change" and "Set voltage and 22KHz" to "yes".
6.1.4 Four satellites via DiSEqC A/B/C/D
Use this type of configuration if you want to receive four satellites from one Single Universal or Twin
Universal LNB for four or eight parties. It does not matter if you use one or two dishes to achieve this.
In this case the LNBs are connected to a so-called Multiswitch from which the signal is via coax cabled to
the satellite receivers (Dreamboxes) in your household.
38
Werbung
