Herunterladen Diese Seite drucken

Siemens Dreambox Two UltraHD Bedienungsanleitung Seite 41

Werbung

Manually setting an IP adress
These settings are only needed if you want to configure your Network manually.
1. With the Navigation-Buttons ( ▲▼) choose the cable based network "Wired" and press the OK-
Button.
2. Press the yellow Options-Button.
3. With the Navigation-Buttons ( ▲▼) choose the option "'Method (IPv4)"' and press the OK-
Button.
4. With the Navigation-Buttons (◄►) choose the option "'manual"' and press the OK-Button.
Address (IPv4) Enter the IP address here.
Free IP-Addresses: 192.168.0.2 - 192.168.0.254
Mask (IPv4) Enter the subnet mask (Usually 255.255.255.0).
Gateway (IPv4) Enter the router's IP address here, if the Dreambox is connected to the Internet by a
router.
Usually this is: 192.168.0.1
To save the settings and activate the network connection press the OK-Button.
DNS-Settings
1. With the Navigation-Buttons ( ▲▼) choose the cable based network "Wired" and press the OK-
Button.
2. Press the blue Options-Button to open the DNS-Settings dialog.
The colored buttons in this menu are mapped to the following functions:
red Options-Button Delete selected nameserver.
green Options-Button Add IPv4-nameserver.
yellow Options-Button Add IPv6-nameserver.
blue Options-Button Skip changes.
Note: If you have set the "Method (IPv4)" option to "dhcp" you won't have to enter anything here
since this will be done automatically.
Nameserver
Enter the DNS-Server's IP address here. DNS is used to translate a Domain name to an IP
address. Normally, if the Type is set to LAN, there is no need for a DNS entry. If the Dreambox is
connected to the Internet over a router, enter the router's IP address here.
3 4

Werbung

loading

Diese Anleitung auch für:

Dreambox 13590 two ultra hd bt 2x dvb-s2x