PETZL NEWTON C73000 Bedienungsanleitung Seite 4

5
How to put the harness on
Open the leg loop buckles and,
holding the shoulder straps,
put on the harness like a vest.
DoubleBack
Fast
6
Fall arrest
6A. Sternal attachment point
EN 361
EN 361
6B. Dorsal attachment point
These points (marked with the letter 'A') are used to attach a
N 361
fall arrest system:
- Either in conjunction with a mobile fall arrester on a rope,
an energy absorber... (systems described by the EN 363
standard).
- Or in conjunction with a rope. For the sternal attachment
point, connect the two sternal rope loops with a figure-eight
knot.
Clearance: amount of free space below the user
The clearance below the user must be sufficient to prevent
the user from striking any obstacle in case of a fall. Specific
details on calculating clearance are found in the technical
notices for the other components (energy absorbers,
mobile fall arrester, etc.).
technical notice NEWtoN 2
All manuals and user guides at all-guides.com
5A. Fasten and adjust
the leg loops.
- NEWTON: DoubleBack
buckles.
- NEWTON FAST JAK: Fasten
the FAST buckles. Be careful
of foreign bodies which can
impede the operation of
the FAST buckles (such as
pebbles, sand, clothing...).
Check for correct locking.
Stow the excess webbing
neatly using the strap
retainers (flat against the waist
belt).
EN 361
5B. Adjust
the shoulder
straps.
Stow the
excess webbing
using the strap
retainer on the
shoulder strap.
7
Work positioning accessories
Two accessories are offered to add work positioning:
7A. Accessory LIFT L54: Spreader.
EN 361
EN 361
7B. Accessory PAD C89:
Work positioning belt.
5C. Close the harness.
ALWAYS connect the two sternal
rope loops with a locking connector.
Adjustment and suspension test
Your harness must be adjusted to fit
snugly to reduce the risk of injury in
case of a fall.
You must move around and hang in
the harness (suspension test) from
each sternal and dorsal attachment
point with your equipment to verify
that the harness fits properly,
provides adequate comfort for the
intended use and that it is optimally
adjusted.
c735080D (190514)
4