switel WTF 727 Bedienungsanleitung Seite 78

Verfügbare Sprachen

All manuals and user guides at all-guides.com

2 x M

X/Y, P

If you want to communicate with the walkie−talkies which are not

using a CTCSS/CDCSS code, you must select CTCSS/CDCSS

code 0" (zero) on your walkie−talkie.

Scanning for a channel

Signals are searched for in the eight channels in a continuous

cycle. The

is detected, the channel scan stops. The Ready LED flashes ev-

ery second. Press the P button to enable radio communica-

tion. If the P button is not pressed, channel scan resumes

after five seconds.

Start/End global channel scanning

To execute a global channel scan", set the CTCSS/CDCSS code

of the output channel to 0 (zero). The scanning routine stops at

every channel on which a signal is received, regardless of the

code transmitted with the signal.

Start/End specific channel scanning

To execute a specific channel scan", set the CTCSS/CDCSS

code for each channel to an individual value.

The scanning routine only stops when a signal is received on a

channel that matches the value set.

Operating the Walkie−Talkies

An exception here is code 0 (zero). In the case of this

setting, all the calls on the set channel can be heard re-

gardless of the CTCSS/CDCSS code. To be able to

participate in the radio communication, it may be

necessary to set the necessary CTCSS/CDCSS code.

icon appears in the display. If an active channel

The output channel is the channel which is set when the

channel scan is activated.

If a certain channel should be scanned fully during a

specific channel scan", the code must be set to 0 (zero)

for this channel.

Activate programming mode

Select the code and confirm it

Start/End channel scanning