Philips AVENT SCD630 Bedienungsanleitung Seite 28

30
English
HOW TO USE / CONNECTING THE UNITS
Where can I turn on the
nightlight?
How can I reset the
parent unit?
HOW TO USE / CONNECTING THE UNITS
Question
Where can I turn on the
nightlight?
INDICATIONS ON THE PARENT UNIT
Question
The battery LED on the
parent unit turns red.
What should I do?
Why does the parent
unit beep?
What does the battery
LED colour (green,
orange, red) or no
burning LED mean for
the status of my
battery?
Press the nightlight on/off button on the baby unit to switch on the
nightlight feature. It is not possible to control the nightlight from the parent
unit. The nightlight does not turn off automatically, press the nightlight
on/off button again on the baby unit to switch it off.
You can reset the Parent Unit by simultaneously press the "power on/off
button" and the round "navigation down button" at the front of the parent
unit for about 1 second. The parent unit will restart and connection will be
re-established. Specific user information stored in the memory of the
parent unit such as user mode, brightness settings, volume, lullaby
selection, zoom selection and vibration settings will not be lost.
Answer
Press the nightlight on/off button on the baby unit to switch on the
nightlight feature. It is not possible to control the nightlight from the parent
unit. The nightlight does not turn off automatically, press the nightlight
on/off button again on the baby unit to switch it off.
Answer
The battery power is low. If you do not connect the parent unit to the mains
power when the battery LED has turned red and starts to make a beeping
sound, the unit will stop working after approximately 60 minutes.
Switch to lower brightness and/or volume to save battery consumption and
connect the parent unit to the mains with the power adapter. (see chapter
'Preparing for use').
Your baby monitor beeps in a certain way to tell you what the problem is.
1 beep: parent unit is switched off.
1 beep, every 20 seconds for the first 3 minutes, after that, every minute:
parent unit is low in battery.
2 quick beeps every 20 seconds: temperature of the baby room is outside
the range that is defined by the user, temperature icon is shown on parent
unit's screen (for model SCD630 only).
3 quick beeps every 20 seconds: connection between parent and baby unit
is lost, link icon is shown on the parent unit's screen and the link connection
button is red.
When the parent unit is connected to the mains power the color of the
battery light will show:
* Green: battery is full.
* Orange: battery is charging.