Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After the hob cools the ´t` displays will be erased and the hob control enters
standby mode. This means that the user can reactivate the appliance by
touching
.
Residual Heat Functions
After the hob is turned off when cooking is finished, there is some heat
stored in the vitroceramic glass called residual heat. The hob can calculate
roughly how hot the glass is. If the calculated temperature is higher than
+ 60 ° C, the corresponding heater display will flash an ´H` symbol. The
residual heat display is shown as long as the calculated heater temperature
is higher than + 60 ° C.
The display of the residual heat has the lowest priority and is overwritten
by every other display value such as safety turn off's and displaying error
codes.
HOB RESET
When the Hob is first turned on after installation or after a power outage
during operation, the Hob will display a flashing ´H` on all or some heater
displays.
Which displays flash an ´H` depends on mode of operation when the power
outage happened.
This is due to the Hob retaining heater information in its memory, this is not
a fault and is normal.
To reset the Hob, press and hold the top left heater, bottom left heater and
the
buttons at the same time for roughly 2 seconds.
hold these buttons
to reset the Hob.
.
.
.
.
.
.
.
Werbung
