Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Turning the appliance on / off .
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button
operation.
On all heaters a ´0` appears and all Decimal Point of the heater flashes.
If there is no operation within 10 sec, the display of all heaters will turn off.
If the displays are turned off, the heater will be set to off.
If
is pressed more than 2 sec (in Operating-Mode), the appliance is
switched off and is set into the off mode again. The appliance can be turned
off by pressing
simultaneously..............................................................................
If there is residual heat remaining, this will be indicated by a flashing H in
the corresponding Heater Display.
Select Heater
If a single heater is chosen with the corresponding Active/Deactive Heater
Button
, the Decimal Point of the related Heater Display flashes. For the
selected heater, you can set the heat level between 1-9 by touching the
Heat Setting Buttons
The buttons must be pressed within 3 sec, otherwise the heater selection
is erased and heat setting dot will disappear (Decimal Point). If there is no
further operation within 10 sec, the heater falls back into off mode.
The heat setting can always be changed by pressing
level 1-9.
Each button operation or each display change is accompanied by a beep.
at least 1 second. A beep indicates a successful
at any time; even if other buttons are pressed
or
.
.
.
.
or
between
.
Werbung
