STEP 5:
Insallaon o he ooress 43 a oores holder
44.
1. Push he righ oores (43R) ono he oores
holder (44R). Adjus he holes in he pars so ha
hey are aligned.
2. Push he screws M6x50 (42) rom above hrough
he holes. Push rom he opposie side on a washer
(45) and spring washer (46), screw on a handgrip nu
(47) and ghen rmly.
3. Insall he lef oores (43L) on he lef oores
holder (44L) as described in 1. – 2. (Noe: The posi-
on adjused in his way should always be equal a
boh sides. The righ and lef ooress can be dis-
cerned by he edges o he longiudinal sides o he
ooress. The high edges o he ooress (43) mus
poin inwards (owards he main rame.) The posi-
ons can change as desired a all mes by removing
he carriage bols (42) and sliding he ooress on
he oores brackes o ge a comorable exercise
posion close o he hand grip.)
STEP 6:
Atach he handle grip 3 a suppor 30.
1. Push a spring washer (32) and a washer (31) ono
each screw M8x20 (33).
2. Place he handle grip (3) agains he holder a
suppor (30) and ghen he handle grip (3) a han-
dlebar suppor (30) rmly.
3. Aach he grip cover (18) a handle grip (3) and
secure wih screw M5x15 (102).
STEP 7:
Atach he compuer 1 a suppor 30.
1. Pu he plug o connecon cable (34) ino he
plug rom compuer (1) backside.
2. Inser he plug o pulse connecon cables (16) o
he jack o he compuer (1) and aach he compu-
er (1) o op monior bracke o ron pos (30) wih
screws M5x10 (15). (Atenon: Ensure that the ca-
ble loom are no crunched or pinched during insal-
laon.)
STEP 9:
Checks
1. Check he correc insallaon and uncon o all
screwed and plug connecons. Insallaon is hereby
complete.
2. When everyhing is in order, amiliarize your-
sel wih he machine a a low resisance setng and
make your individual adjusmens.
Noe:
Please keep he ool se and he insrucons in a sae
place as hese may be required or repairs or spare
pars orders becoming necessary laer.
16
GB