Before Operating - Wolf Garten Campus 250 RT Originalbetriebsanleitung

z Use trimmer when the weather is dry and do
not leave it outside when it rains.
z Use a residual current device (RCD) rated for
a residual current not greater than 30 mA.
z Never install metal cutting elements.

Before operating

z Before starting the trimmer, clear all string,
wire etc. away from the area to be cut. Whilst
cutting look out for foreign objects.
z All cable must be inspected regularly for signs
of damage or ageing. Use only in perfect con-
dition!
z Tool must not be used when the safety device
or the covering is damaged.
z For safety reasons only original WOLF spare-
parts or parts appointed by the manufacturer
shall be used. Please note the installation ins-
tructions!
z Before adjusting or cleaning the tool and be-
fore checking for a caught or damaged con-
necting cable, switch off the tool and
disconnect the mains plug.
z Before starting the unit, and after any impacts,
examine the unit for signs of wear or damage.
Have any detected damage repaired immedia-
tely.
Cable
z Use only extension cables with a minimum
cross-section of 3x1.5mm
max. 25 m:
– When using rubber-sheathed cables, they
must be of typeHO7RN-F or heavier.
–
When using PVC-sheathed cables, they
must be of type HO5 VV-F or heavier
(cables of this type are not suitable for con-
tinuous outdoor use - e.g. underground in-
stallation for the connection of an outdoor
socket or pond pump, or outdoor storage).
z They must be waterproofmobile decvices that
are used outdoors must be connected via a re-
sidual current circuit breaker.
z Use a leakage-protective system (RCD) with a
leakage current of no more than 30 mA.
z Attach connection cable to traction relief.
Make sure that in does not rub against edges,
pointed or sharp objects. Do not squeeze ca-
ble through door or window gaps.
G
2
and a length of
z Switching devices must not be removed or
bridged (e.g. tying of switching lever to guide
spar).
Working
z Always keep hands and feet well clear of the
cutting mechanism, particularly when starting
the unit.
z Avoid injury from each of the components
which serve to cut the line length. After pulling
out a new length of line, always hold the unit in
its normal operating position before starting it.
z When starting the trimmer hold its base paral-
lel to the lawn area in order to avoid accidents.
z Keep your hands away from the moving cord.
z Wear eye protection!
z Always wear appropriate working clothes and
sound footwear when using the trimmer.
z Before carrying the trimmer to the next lawn
area to be cut, switch it off.
z Be careful when you go backwards. You may
stumble!
z Keep the cable away from the cutting tool.
z Should the powercord be damaged during
use, immediately disconnect it from the mains.
Do not touch the cable until it has been discon-
nected from the mains.
z Never leave the trimmer without supervision.
Store it in a safe place.
z The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the
handle.
z Do not allow the cord spool to strike the ground
or edges of working area. If the cord spool re-
ceives a hard knock, this will cause a strong vi-
bration on the handle. If this occurs, the
trimmer should be checked by a qualified ser-
vice centre.
After operating
z After using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.
z When switching off the trimmer: Attention: the
cutting tool does not stop immediately!
z Always wait for the cutting tool is stop.
12