Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In case of difficulty
What appears to be a malfunction may not always be serious. First, check the following items before consult the ser-
vice personnel.
Symptom
Causes
Numbers on the tape counter dif-
fers when replacing the tape. (C-
46, C-90 cassettes, etc.)
The tape thickness or cassette shell
design differs according to its length
or models. (Difference of reel hub.)
Recording
is
impossible
pressing the REC/ARM key.
:
1. The safety tab provided with the
cassette shell is broken.
2. Cassette
holder
is not
closed
completely.
3. Record input level knob is set to
minimum position.
Remedy
Caused
by the difference
of tape
model, it's not a malfunction.
1. Use the cassette with its safety
tab. (When
recording
using the
cassette
with
the
tab
broken,
block hole with adhesive tape.)
. Close the cassette
holder com-
pletely.
. Refer
to the
'Tape
recording"
section.
Sound
is not heard
even
when | 1. Audio cords are connected incor-
the play key is pressed.
recly.
2. Head is dirty.
3. Tape cannot be advanced caused
by uneven winding.
4. Unrecorded tape is used.
. Refer to the System connections"
section.
. Refer
to
the
section.
. Replace the cassette.
"Maintenance"
. Use the recorded tape.
Sound is husky or high frequen-
cy notes are not heard.
1. Head is dirty.
2. Tape is damaged.
Sound is distorted.
Too noisy.
1. Recording level is too high when
recording.
2. Source itself is distorted.
1. Head is magnetized.
2. Noise is inducted from the exter-
nal equipment.
3. Recording level is too low.
4. Dolby
encoded
tape
is played.
back with Dolby switch OFF.
Sound is winding.
DPSS
does not function
correct-
ly.
|
Capstan or pinch roller is dirty.
2. Tape is wound unevenly.
The unsuitable tape having shorter
blank
section
between
turnes
is
used.
The unit does not function even
when
the
operation
key
is
pressed.
Note:
The
tape
cannot
be wound
(adv-
anced) because
the tape is wound
unevenly.
. Refer
to
the
''Maintenance"
section.
. Replace the cassette.
Refer
to
the
'Tape
recording"
section.
1. Demagnetize
the
head
head eraser.
. Keep the unit away from other
electrical equipment.
. Refer
to the
"Tape
recording"
section.
. Set the Dolby NR switch to ON. It
is recommended
to perform
re-
cording always using the Dolby
NR switch ON.
. Refer
to
the
section.
. Wind the tape again by fast-for-
warding or rewinding.
Refer to the "DPSS" section.
using
Maintenance"
Replace the cassette.
The 120-minute cassette tapes are unrecommendable because they are too thin and may be damaged by the repeated use.
KX-76R (E)
11
Werbung
