Werbung
Verfügbare Sprachen
Verfügbare Sprachen
and maintain low noise levels.
Use
The hood can be used both in aspiration
mode with external discharge of suctio-
ned air, and in filtering mode, where the
air is recycled back into the room.
Aspiration Mode
Vapours are discharged to the outside,
through the specific exhaust pipe fixed
to the flange.
The exhaust pipe diameter shall be the
same as the connection ring diameter.
Filtering Mode
The air that is sucked in will be 'degre-
ased' before being re-conveyed into the
room. You need to buy the specific SEE
YOU Filtering version KIT, if you wish to
use the hood in this mode.
The kit will include: long life charco-
al filters (Fig. 13), and some pipes for
conveying the air to the front side of the
hood.
Note: The air recycled through the char-
coal filters is conveyed back into the
kitchen through a duct that conveys the
air along a side of the cabinet.
Installation
Note: installation shall be performed in
such a way as to allow that the hood
and its electric components can be ea-
sily accessible in case of technical as-
sistance.
WARNING: Place the metal box contai-
ning the electronic components at a mi-
nimum distance of 65 cm from the gas
hob or anyway at 65 cm from the hood
aspiration area.
RECOMMENDATION: we advise that
you install the metal box, containing the
electronic components, at 10 cm from
the floor, at least, and at a safe distan-
ce from any heat source (e.g.: an oven
side, or a hob ).
In the case that the installation instruc-
tions of your gas cooker mention a hi-
gher distance, please comply with this
requirement.
Electrical Connection
The connection of the hood to the power
supply shall be performed by qualified
and specialised technical personnel.
The mains voltage shall correspond
to the voltage value specified on the
rating label found inside the hood. If
the appliance is equipped with a plug,
the hood shall be connected to a so-
cket which is compliant to the relevant
standards in force, and which is loca-
ted in an easily reachable area, also
after installation. If the appliance is not
equipped with a plug (direct connection
to power supply), or if the plug is not
found in an easily reachable place after
installation, use an approved double-
pole main switch, ensuring complete
disconnection from the power supply at
the overvoltage category III conditions,
in accordance with the installation pro-
cedure.
Caution! Before reconnecting the hood
electric circuit to the power supply, and
to check for proper operation, please
always make sure the mains lead has
been installed properly.
Installation
Before carrying out the appliance in-
stallation, please check that all compo-
nents are not damaged, in such a case
contact your retailer and do not proceed
with any further installation step.
13
Werbung
