Caliber MCD 300M Anleitung Seite 3

5 . B A S I C O P E R AT I O N S
14) PANEL RELEASE BUTTON (REL)
Press this button to remove the control panel.
1) POWER ON/OFF BUTTON
Press PWR button or any other button on the front of the radio (except Open/Eject)to
turn the unit on. Press PWR button again to turn the unit off.
2) MODE BUTTON (MODE)
Press MODE button to select a different mode of operation as indicated on the display
panel. Available modes include Tuner, CD, CARD, USB mode .
3) PWR BUTTON (MUTE)
Press the PWR button momentarily to mute the audio volume, and "Mute" will flash in
the display. Press the PWR button again to restore volume to the previous setting.
4) VOLUME KNOB
To increase the volume rotate the volume knob clockwise, to decrease the volume rota-
te the volume knob anticlockwise.
Press the VOLUME knob, the display will be displayed first option is Volume, Bass,
Treble, Balance, Fader and back to Volume. >>
When adjusting audio functions, the unit will automatically exit audio control mode
after 5 seconds of inactivity. Use the volume knob to adjust the settings.
8) DISPLAY (DSP)
Selects the radio frequency, clock display and PTY NONE.
To set the clock:
1. With clock display selected, hold down the "DISP" button until clock display starts
flashing.
2. Rotate the volume knob to change minutes and hours.
3. Press "DISP" button to start the clock
Pressing the "DISP" key will display the following modes;
In case of receiving a RDS station:
Tuner mode PS – PTY – FREQ – CT
CD/MP3 player mode CDP – PS – PTY – FREQ – CT
In case of receiving NON RDS station
Tuner mode CLOCK – FREQ – NO PTY
CD/MP3 player mode CDP – FREQ – CT – NO PTY
CT = clocktime
6 . T U N E R O P E R AT I O N
11) TUNING UP/DOWN BUTTON
Manual Tuning
Press the Up Tuning or Down Tuning button for more than 3 seconds to move the radio
frequency number up or down one step.
Auto Seek Tuning
Press the Up Tuning or Down Tuning button for less than 3 seconds to move to next
station automatically.
12) PRESET STATIONS BUTTONS
Six numbered preset buttons store and recall stations for each band (3 FM bands).
Store a Station
Select a band (if needed), then select a station. Hold a preset button for 3 seconds.The
preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button to select the corresponding stored station.
13) AUTOMATICALLY STORE / PRESET SCAN (A/PS)
Automatically Store
Automatically select 6 strong stations and store them in the current band. Select a band
(if needed). Press A/PS button for more than three seconds.The new stations replace
stations already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press A/PS button
for less than 3 seconds.The unit will pause for ten seconds at each preset station. Press
A/PS button again to stop scanning when the desired station is reached.
Stereo
The unit will automatically pick up a stereo signal, if stereo signal is available.When in
stereo mode, the ST icon will appear on the display.
7 . C D P L AY E R O P E R AT I O N
INSERT AND EJECT CD
Insert a CD label-side up with the unit turned on, and the disc will begin to play. Press
the Eject button to stop CD play and eject the CD.The unit does not have to be turned
on to eject the CD.
PAUSE BUTTON (PAU)
Press the pause button to suspend disc play. Press the pause button again to resume disc
Play.
3