HBK HBM CFT+ Montageanleitung Seite 5

1 SAFETY INSTRUCTIONS
Intended use
Piezoelectric force transducer in the CFT+ type series are designed solely for measuring
static and dynamic compressive forces within the load limits stated in the specifications.
Any other use is not the intended use.
To ensure safe operation, it is essential to comply with the regulations in the mounting
instructions, the safety requirements listed below, and the data specified in the technical
data sheets. It is also essential to observe the applicable legal and safety regulations for
the relevant application.
Force transducers are not intended for use as safety components. Please also refer to
the "Additional safety precautions" section. Proper and safe operation of force transduc­
ers requires proper transportation, correct storage, setup and mounting, and careful oper­
ation.
Load carrying capacity limits
Comply with the information in the technical data sheets when using force transducers.
The respective specified maximum loads in particular must never be exceeded. The fol­
lowing limits set out in the technical data sheets must not be exceeded:
S
Force limits
S
Lateral force limits
S
Breaking forces
S
Maximum eccentricity
S
Permissible dynamic loads
S
Temperature limits
Please note that when several force transducers are interconnected, the load/force distri­
bution is not always uniform. This means that one particular force transducer may be
overloaded even if the total of all the nominal (rated) force for all sensors has not been
reached.
Use as machine elements
Force transducers can be used as machine elements. Note also the "Load-carrying capac­
ity limits" section and the specifications to ensure the required overload limit of your ap­
plication.
Accident prevention
The prevailing accident prevention regulations must be taken into account, even though
the breaking force is well in excess of the full scale value.
CFT+
SAFETY INSTRUCTIONS
3