Stihl NG 5 Gebrauchsanleitung Seite 11

Rivet Spinning
Non-approved combinations of
cutters and/or chain links can
increase the kickback tendency of
the chain and expose the user to
injury.
Wear protective gloves when
working with the saw chain to
protect your hands from the sharp
cutters.
:
Select the spinning head and thrust
screw to suit the chain pitch.
STIHL Oilomatic Spin-
saw chain ning
head
1/4" Rapid,
3/8" Picco,
0.325" Rapid C
3/8" Rapid ,
0.404" Rapid A
1/2", 15 mm
Rapid Micro B
A
NG 5
: Do not change the chain link
assembly pattern.
: Use only identical replacement
chain links.
1
Thrust
screw
:
Screw the thrust screw (1) into the
theaded bushing (2) clockwise.
:
Fit the spinning head (3) in the
holder (4).
C
A, B
A, B
2
3 4
: Fit the matching chain links on a
preset tie strap and place the chain
over the two guide pulleys (5) – the
drive link tangs engage the groove.
:
Loosen the screws (6) and rotate
the eccentric guide pulleys until the
rivets in the chain links are
horizontal and in alignment with
spinning head. The preset head of
the tie strap must locate in the
recessed end of the thrust screw.
: Tighten down the screws.
English
5
5
6
6
11