Werbung
Statement 4024—Software or Firmware No Supported/Provided
The use of software or firmware not supported/provided by the manufacturer may result in the equipment no
longer being compliant with the regulatory requirements.
Statement 4031—Electromagnetic Field (EMF) Standards
To ensure compliance with various national and international Electromagnetic Field (EMF) standards, the
system should only be operated with Cisco approved antennas and accessories.
Statement applies to: ASA 5506W-X
Statement 4032—Exposure Limits to Radio Frequency Fields
To ensure compliance with exposure limits to radio frequency fields, the antenna of should be no closer than
20 cm from the body during use.
Statement applies to: ASA 5506W-X
Statement 4033—Australian Class Licences
A radio communications device supported under Australian Class Licences can be expected to be operating
in radio frequency spectrum also used by other radio communications devices (that is, it shares the spectrum
with them). Devices supported under Class Licences are typically used for communications over short distances.
Statement applies to: ASA 5506W-X
Statement 4034—Take Measure to Resolve Interference
Should interference occur, the onus is on the user of a spread spectrum device to take measure to resolve that
interference, for example, by re-tuning or ceasing to operate the device.
Statement applies to: ASA 5506W-X
Regulatory Compliance and Safety Information—ASA 5506-X, 5506H-X, 5506W-X, 5508-X, 5516-X
12
Regulatory Compliance and Safety Information—ASA 5506-X, 5506H-X, 5506W-X, 5508-X, 5516-X
Werbung
