Werbung
Statement 391—Low-Power Radio Data Communications
Systems (ARIB-STD)
This equipment shares a frequency band with a wide range of equipment: e.g. industrial, scientific, and medical
Warning
equipment such as microwave ovens, premises radio station (radio stations requiring licenses), and specified
low-power radio stations (radio stations not requiring licenses) for RFID used for factory production lines as well
as amateur radio stations (radio stations requiring licenses).
1. Before use, confirm that no premises radio stations and specified low-power radio stations for RFID or amateur
radio stations operate in your vicinity.
2. In the event that this equipment causes harmful interference to any premises radio station for RFID, immediately
change frequencies or halt radio wave emission and contact us at the information indicated below for consultation
on interference avoidance measures (e.g. partition installation).
3. Contact us at the information indicated below URL if this equipment causes harmful interference to any specified
low-power radio stations for RFID or amateur radio stations or if other problems arise.
http://www.cisco.com/jp/
Statement applies to: ASA 5506W-X
Statement 1002—DC Power Supply
When stranded wiring is required, use approved wiring terminations, such as closed-loop or spade-type with
Warning
upturned lugs. These terminations should be the appropriate size for the wires and should clamp both the insulation
and conductor.
Statement 1006—Chassis Warning for Rack-Mounting and
Servicing
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure
Warning
that the system remains stable. The following guidelines are provided to ensure your safety:
•
•
•
Regulatory Compliance and Safety Information—ASA 5506-X, 5506H-X, 5506W-X, 5508-X, 5516-X
6
Regulatory Compliance and Safety Information—ASA 5506-X, 5506H-X, 5506W-X, 5508-X, 5516-X
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit
in the rack.
Werbung
