CombiSteel 7455.0930 Gebrauchsanweisung Seite 7

Faults
Fault
Appliance does not do
anything
Appliance remains cold
Appliance remains cold
Appliance does not
reach the set
temperature
/ long frying time
/ too high temperature
If after these controls, the malfunctioning continues, it is advisable to contact your supplier for assistance. In
case of any doubt, always contact your supplier!
1) Reset overload circuit breaker
- Allow the deep fryer to cool down.
- Remove the detachable control panel from the support.
- Unscrew the black protective cap from the bottom of the detachable control panel.
- Press the "reset button" of the overload circuit breaker. You should hear a clear click.
- Screw the black protective cap back on.
- Reinstall the detachable control panel on the support.
Warranty
Any defect affecting the functionality of the appliance that becomes apparent within one year after purchase
will be corrected by free repair or replacement provided the appliance has been used and maintained in
accordance with the instructions and has not been abused or misused in any way. Your statutory rights are not
affected. If the appliance is claimed under warranty, state where and when it was bought and include proof of
purchase (f.e. receipt).
In line with our policy of continuous product development we reserve the right to change the product, packaging
and documentation specifications without notice.
Discarding & Environment
At the end of the life of the appliance, please dispose of the appliance according to the regulations and guidelines
applicable at the time. Throw packing materials like plastic and boxes in the appropriate containers. Used frying
oils and fat dispose according to legal regulations and guidelines.
Symptom
Green switch light and
orange lamp do not light
Green switch light and
orange lamp do not light
Green switch light and
orange lamp light
www.combisteel.com
Possible cause
No mains voltage
Switch is off
Check if the thermostat
is on
Thermostat defective
Detachable control panel
is not correctly
positioned on the
support
Overload circuit breaker
tripped
Micro-switch defective
Overload circuit breaker
defective
Thermostat defective
Possible solution
Check the electrical
installation
Turn on the switch
Switch defective
Turn on the thermostat
Contact your supplier
Install the detachable
control panel correct on
the support. See
Installation.
Reset the overload
circuit breaker.
See note 1)
Contact your supplier
Contact your supplier
Contact your supplier
7